Installing the parking assistance module (PAM) and relay
●
Connect the control module to the pre
-routed cable harness. Use the black
connector from the existing cable harness
● Connect the cable harness from the sensors to the control module.
Installing the parking assistance module (PAM) and relay
● Remove the backing from the Velcro strips.
Installing the parking assistance module (PAM) and relay
● Press the control module firmly into place on the flat surface, with the wiring
positioned behind the existing thick cable harness as illustrated.
The left side of the control module must be at the same height as the edge of the
plate (1).
Installing the parking assistance module (PAM) and relay
● Reinstall the expanded polystyrene seal together with the cable harness from
the sensors in the hole in the rear cross member.
Installation instructions, accessories
-
Parking assistance module (PAM),
rear
Installation instructions, accessories
-
Parking assistance module (PAM),
rear
©
VolvoCar Corporation, 2004 Printed in Sweden
©
VolvoCar Corporation, 2004 Printed in Sweden
Page 18 of 20
Comments to this Manuals