Installing the sensors
●
Take the
27.5 mm (1 1/16”)
diameter hole cutter (P/N 8671170). Install the hole
cutter in the holes; with the screw and the counterhold on the inside and the
cutting section on the outside as illustrated. Ensure that both parts of the hole
cutter are correctly positioned against the surface of the bumper cover before
starting to make holes
●
Expand the holes
● The mark on the tool must be pointed upwards and correspond to the centre
marking on the cover.
Note!
Clean the threads and surfaces of the tool after cutting each hole.
Installing the sensors
● File out the two semi-circles marked around each hole. Use a small round file.
These ensure that each sensor is correctly positioned and does not rotate. The
two sensor holders which will be in the centre (1) are the same. The two sensor
holders which will be positioned to the sides (2) are different from each other
and from the sensors in the centre. The catches on the holders also have text
indicating the correct location in the bumper.
Note!
The marking may be difficult to see. Carefully check that each sensor holder is correctly
positioned.
Installing the sensors
● Ensure that the edge of the holes are smooth. File the holes if necessary
● Remove the protective paper around the holes
● Take the sensor holders from the kit. Press them into the correct positions in the
bumper cover. Press the sensor holders firmly into place. Check that all the
catches have engaged.
Installation instructions, accessories
-
Parking assistance module (PAM),
rear
Installation instructions, accessories
-
Parking assistance module (PAM),
rear
©
VolvoCar Corporation, 2004 Printed in Sweden
©
VolvoCar Corporation, 2004 Printed in Sweden
Page 10 of 20
Comments to this Manuals