Installing the parking assistance module (PAM) and relay
Illustration A shows the removal of the cover for the load securing eyelets
● Fold out the load securing eyelet
● Insert a scriber with an angled tip into the hole in the top of the cover
● Turn the scriber so that the angled tip engages in the reverse of the cover (1).
Pull the cover off.
Illustration B applies to cars with two rows of seats
Illustration C applies to cars with three rows of seats
● Remove the two screws (2) from under the cover
● Remove the covers (3) over the front mountings for the left-
hand side panel. Pry
the covers off. Use a plastic weatherstrip tool or a small screwdriver
● Remove the screws (4)
●
Remove the clip (5) at the bottom of the storage compartment in the panel
(Applies to cars with three rows of seats)
●
Pull out the panel slightly at the top edge so that the clips on the inside release.
Remove the panel by pulling it straight upwards.
Installing the parking assistance module (PAM) and relay
● Clean the flat surface where the Velcro strips will be applied. Use a mixture of
30% windscreen washer fluid and 70% water
● Wipe dry.
Installation instructions, accessories
-
Parking assistance module (PAM),
rear
Installation instructions, accessories
-
Parking assistance module (PAM),
rear
Comments to this Manuals