Installing the sensors
● Remove the expanded polystyrene seal on the left-hand side in the rear cross
member under the left
-hand side floor hatch. Do not damage the seal, it will be
used again.
Installing the sensors
● Fold up the lower tailgate
● Reinstall the bumper. Insert the cable from the sensors in the large rectangular
hole to the left in the rear cross member and then on to the hole where the
expanded polystyrene seal was located. Ensure that the wiring for the
sidemarker lamps is in the correct grooves in the spaces under the tail lamps
● Press the four clips for the bumper into place above the sidemarker lamps on the
body. Then secure all the clips for the ends to the body
● Fold down the lower tailgate
●
Tighten the bumper using the four nuts. Tighten to
16 Nm (12 lbf.ft.)
● Take the new pieces of insulation and reinstall them above the holes for the
bumper
● Connect the connectors to the sidemarker lamps
●
Reinstall the covers under the tail lamps
● Rivet the bumper into place at the rear edges of the wheel arches on both sides.
Use the rivets from the kit.
Installing the parking assistance module (PAM)
Points 29-33 apply to four wheel drive cars, and all cars from model year 2005-
● Clean the flat surface on the panel behind the control module where the Velcro
strips will be pressed into place. Use a mixture of 30% windscreen washer fluid
and 70% water
● Wipe dry.
Note!
The relay does not need to be installed on four-wheel drive cars.
Installation instructions, accessories
-
Parking assistance module (PAM),
rear
Installation instructions, accessories
-
Parking assistance module (PAM),
rear
©
VolvoCar Corporation, 2004 Printed in Sweden
©
VolvoCar Corporation, 2004 Printed in Sweden
Page 14 of 20
Comments to this Manuals