Volvo MD22L Owner's Manual download pdf (Page 31)

Launching

Measures in connection with recommissioning - launching

If Volvo Penta engine oil has been used during lay up

only the level needs to be checked.

If a inhibiting oil has been used, both the oil and

the filter must be changed. See under “Service

every 200 hours of operation”.

Check the tightening of all hose-clamps. Check that

all drain-cocks are closed and tight. Clean the engine

and reverse gear on the outside. Check the exhaust-

hoses. Install the impeller.

Check the turbochargers wast gate valve (TMD22) by

turning the shaft according to the picture.

Fill-up the freshwater system to the correct level. Fill-

up through the filler-hole on top of the heat exchanger

with a 50% mixture of freshwater and rust-proofing

ethylene glycol or additive.

Check the zinc ring* on the S-drive and replace if it is

consumed more than 50%. Otherwise clean the

anode (also a new one) with an emery cloth to re-

move the oxide layer. NB. This should be done shortly

before launching.

NOTE! Steel brushes or other steel tools must not be

used for cleaning, as these may reduce the galvanic

contact between the anodes and the drive.

* NB: A magnesium anode should be used when running in

freshwater.

7736943 - Gedownload van www.volvopenta.com 8-2-2009 23:14:15

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 43 44

No comments

Volvo MD22L Owner's Manual Page 31