06 Maintenance and specifications
194
Lamps
06
Courtesy lighting
1. Insert a screwdriver at the short end of the
lens closest to the tunnel console and turn
gently so that the lens comes loose.
(Applies to both lamps).
2. Turn carefully until the lens comes
loose.
3. Replace the bulb.
4. Refit the lens.
Cargo area lighting
1. Insert a screwdriver and gently prise so
that the lamp housing comes loose.
2. Replace the bulb.
3. Check that the bulb illuminates and
press back the lamp housing.
Vanity mirror lighting
Removing the mirror glass
1. Insert a screwdriver underneath the lower
edge, in the centre. Carefully prise up the
lug on the edge.
2. Insert the screwdriver underneath the
edge on the left and right-hand sides (by
the black rubber sections), and prise
carefully so that the glass comes loose
in the lower edge.
3. Carefully detach and lift aside the entire
mirror glass and cover.
4. Replace the bulb.
Fitting the mirror glass
1. Press the three lugs at top edge of the
mirror glass back into position.
2. Then press the three lower lugs back
into position.
NOTE
Before starting to replace a bulb, read
through page 189.
G021757
G021758
G021759
Comments to this Manuals