Assembling the holder
Illustration A
● Install the spacer in the bottom of the holder.
Illustration B
● Ensure that the holder's two screw turrets align between the small pins in the
oblong holes in the spacer. A click should be heard when the spacer is securely
in position.
Assembling the holder
●
Place the connector in the bottom of the hole. The guide hole (1) in the
connector's circuit board must align in the corresponding pin at the bottom of the
holder and the holes (2) in the circuit board must be over the holder's screw
turret.
Assembling the holder
● Take the small torx screws and carefully tighten the connector to the holder.
Ensure that the connector's circuit board is properly against the screw turret and
that there is no play.
● Remove the butyl tape from the screws.
Installation instructions, accessories
-
Navigation system portable
Volvo Car Corporation G
öteborg, Sweden
Installation instructions, accessories
-
Navigation system portable
Volvo Car Corporation G
öteborg, Sweden
©
VolvoCar Corporation, 2007 Printed in Sweden
©
VolvoCar Corporation, 2007 Printed in Sweden
Page 6 of 15
Comments to this Manuals