Volvo 2009 XC90 Owner's Manual Page 183

  • Download
  • Add to my manuals
  • Print
  • Page
    / 290
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 182
07 Wheels and tyres
Emergency puncture repair*
07
182
* Option/accessory, for more information, see Introduction.
pressure is 1.8 bar and maximum is
3.5 bar.
11. Switch off the compressor and unplug the
cable from the 12 V socket.
12. Detach the hose from the tyre valve and fit
the valve cap.
13. As soon as possible, drive approximately 3
km at a maximum speed of 80 km/h so that
the sealing fluid can seal the tyre.
Rechecking the repair and pressure
1. Reconnect the equipment.
2. Read the tyre pressure on the pressure
gauge.
3. If it is below 1.3 bar then the tyre is insuf-
ficiently sealed. The journey should not be
continued. Contact a tyre centre.
4. If the tyre pressure is higher than 1.3 bar,
the tyre must be inflated to the pressure
specified on the tyre pressure decal.
Release air using the pressure reducing
valve if the tyre pressure is too high.
WARNING
Do not unscrew the bottle, it is equipped
with a reverse catch to prevent leakage.
5. Switch off the compressor. Detach the air
hose and cable. Refit the dust cap.
NOTE
The sealing fluid bottle and hose must be
replaced after use. Replacement must be
performed by an authorised Volvo work-
shop.
WARNING
Check the tyre pressure regularly.
6. Return the emergency puncture repair kit
to the cargo area.
7. Drive to the nearest authorised Volvo work-
shop for the replacement/repair of the
damaged tyre. Advise the workshop that
the tyre contains sealing fluid.
WARNING
You should not drive faster than 80 km/h
after the emergency tyre repair kit has been
used. Contact an authorised Volvo work-
shop for inspection of the sealed tyre (maxi-
mum driving distance is 200 km). The staff
there can determine whether or not the tyre
can be repaired or if it needs to be replaced.
Inflating the tyres
The car's original tyres can be inflated by the
compressor.
1. The compressor must be switched off.
Make sure that the switch is in position 0
and locate the cable and air hose.
2. Unscrew the wheel's dust cap and screw
in the air hose valve connection to the bot-
tom of the thread on the tyre's air valve.
WARNING
Do not leave children in the car without
supervision when the engine is running.
WARNING
Inhaling car exhaust fumes can result in
danger to life. Never leave the engine run-
ning in sealed areas or areas that lack suf-
ficient ventilation.
3. Connect the cable to one of the car's 12 V
sockets and start the car.
4. Start the compressor by flicking the switch
to position I.
Page view 182
1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 289 290

Comments to this Manuals

No comments