Volvo C30 Electric Owner's Manual download pdf (Page 26)

01 C30 ELECTRIC

Maintenance and service

24

Following this the Recovery cable is connected

- proceed as follows:

Connection point for the Recovery cable.

IMPORTANT

Hold the connectors when disattaching - do

not hold and pull the electrical cables.

1. First, make sure that the rear wheels are

blocked in some way, e.g. with chocks or

similar.

2. The check that the parking brake is

released. See separate instructions in the

section "Parking brake - emergency dis-

engagement".

3. Locate the Recovery cable's connection

point (A).

4. Press and release the catch for the con-

nectors and pull out the right-hand half to

the right (seen from the driver's seat).

5. Connect the Recovery cable's connector

in the loosened "right-hand connector

half" - press the connector halves together

until they lock with a "click".

6.

Connect the Recovery cable's black

clamp to the negative terminal on a

12 V DC battery.

7.

Then hold the Recovery cable's red clamp

to the positive terminal of the

12 V DC battery for a few seconds - a

sound can be perceived from the electric

motor as it disengages the inhibitor.

8. Check that the car can be rolled a few dec-

imetres forward/backward in order to verify

that the inhibitor has released.

9. Remove the Recovery cable from the bat-

tery.

10.

NOTE: Do not reconnect the car's con-

nectors to the now "empty" connector half

(A) again - leave it for the Volvo workshop

where the car is recovered to.

11. Align the cover's 4 rubber caps over each

stud and push the cover into place.

12. Refit the Recovery cable in the cargo area.

If this process does not work - contact a work-

shop, see page 4 for information on a suitable

workshop.

WARNING

Chock the wheels before the parking lock is

disengaged manually with the Recovery

cable - otherwise the car could start to move

uncontrollably.

•

Use chocks for the rear wheels.

Washing the car

As the car is equipped with components

designed for connection to 230 V AC high-volt-

age, it is very important that these parts are not

exposed to moisture, fluids and/or aggressive

chemicals and/or solvents.

IMPORTANT

Do not wash the space under the bonnet

with a high-pressure unit.

automatic car wash

In an automatic car wash - where the car is

towed through the cleaning system - the

wheels must be able to roll freely. In which

case, proceed as follows:

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 35 36

Comments to this Manuals

No comments