01 C30 ELECTRIC
Climate
20
WARNING
The heater generates unhealthy emissions
during operation with fuel. Program the
timer for electric operation when the car is
used - or parked - in an enclosed/unventi-
lated area.
Timer-set heating/cooling
The climate control system can be pre-pro-
grammed to heat the passenger compartment
- within 24 hours - before setting off.
The time that is programmed refers to when the
car shall be used. Proceed as follows:
1. Turn the remote control key to key position
I.
2.
Select the
PRECONDITIONI. TIMER 1
--:--
menu with left-hand stalk switch
thumbwheel.
3.
Briefly press RESET - the character posi-
tion for hour starts flashing.
4. Select the required hour with the thumb-
wheel and briefly press RESET - the char-
acter position for minutes starts flashing.
5. Select the required minute and briefly
press RESET.
6.
Finish with a long press on RESET - pro-
gramming is complete and the display
shows
TIMER ACTIVE FOR
PRECONDITIONI.
.
Following which, the climate system automat-
ically selects a suitable start time.
There is more information about programming
the time on the normal owner's manual. Note
then that what is designated in the C30
ELECTRIC as
PRECONDITIONI. TIMER 1 is
the equivalent of
PARK HEAT TIMER 1 in a
conventional C30.
On page 30 in this supplement there are
examples of more climate-related menus.
Timer-set heating/cooling with the car
connected to mains electricity
When the car is connected to mains electricity,
the batteries will always be used as the energy
source for the heating.
•
If necessary, the passenger compartment
is cooled with the AC.
Timer-set heating without connection to
mains electricity
When the car is not connected to mains elec-
tricity fuel is used as the heat source. In which
case, please note the following:
NOTE
•
When the car is not connected to mains
electricity the "Timer-set heating" can
only be activated if the
FUEL HEATER
AUTO - ON
menu option is selected.
•
Cooling of the passenger compartment
via AC is not possible when the car is
not connected to mains electricity.
Continuous heating/cooling
If the driver wants the car warmed up or cooled
down in advance, but does not know what time
the car will be used, then the climate control
system can be programmed to heat/cool con-
tinuously.
In which case, proceed as follows:
1. Connect the car to the 230 V AC mains cir-
cuit.
2. Follow the preceding instructions for pro-
gramming and select the time
00:00 for
TIMER 1 or TIMER 2 - the climate control
system will then keep the car constantly
"ready to start" with heated/cooled pas-
senger compartment and fully charged
batteries.
The "Continuous heating/cooling" function is
active until the time
00:00 is replaced with
--:-- or another time.
(35 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals