Volvo 2011 S80 Owner's Manual download pdf (Page 261)

07 Maintenance and specifications

Replacing bulbs

261

NOTE

•

Always switch off the ignition before

starting to replace a bulb.

•

The optional Active Bending Light bulbs

contain trace amounts of mercury.

These bulbs should always be disposed

of by a trained and qualified Volvo serv-

ice technician.

Removing the headlight housing

1. Switch off the ignition by briefly pressing

the START/STOP ENGINE button and

remove the remote key from the ignition

slot

2. (Upper illustration under "Headlight hous-

ing")

Withdraw the headlight housing's lock-

ing pins.

Pull the headlight housing straight out.

CAUTION

When disconnecting the connector, pull on

the connector itself and not on the wiring.

3. (Lower illustration under "Headlight hous-

ing")

Unplug the wiring connector by holding

down the clip with your thumb.

Pull out the connector with the other

hand.

4. Lift out the housing and place it on a soft

surface to avoid scratching the lens.

5. Replace the defective bulb(s).

Reinserting the headlight housing

1. Plug in the connector until it clicks into

place.

2. Reinstall the headlight housing and locking

pins. Check that they are correctly

inserted. The headlight housing must be

properly inserted and secured in place

before the lighting is switched on or the

remote key is inserted into the ignition slot.

3. Check that the lights function properly.

Removing the cover to access the

bulbs

G021745

NOTE

Before starting to replace a bulb, see

page 260.

1. Open the retaining clamp by pressing it to

the side.

2. Press down the clips on the upper edge of

the cover and remove it.

Reinstall the cover in the reverse order.

Does not apply to vehicles with the optional keyless drive.

1 2 ... 256 257 258 259 260 261 262 263 264 265 266 ... 311 312

Comments to this Manuals

No comments

Volvo 2011 S80 Owner's Manual Page 261

Comments to this Manuals

Related products and manuals for Cars Volvo 2011 S80