Preparations
●
Turn the ignition key to position 0. Remove the ignition key from the ignition
switch.
● Disconnect the battery negative lead.
Note!
Wait at least three minutes before unplugging the connectors or removing other
electrical equipment.
Removing the 3-spoke steering wheel
●
Reinsert
the ignition key and turn it to position "I" to prevent the steering lock from
engaging.
● Turn the steering wheel a quarter turn so that the holes on the reverse of the
steering wheel are accessible.
Removing the 3-spoke steering wheel
● Insert a screwdriver in the hole (2) on the reverse side of the steering wheel at
right angles to the rear surface.
Insert the screwdriver as far as possible to locate the end of the locking spring
(1).
● Position the end of the screwdriver on the top of the spring clip as illustrated
● Pry the screwdriver upwards towards the upper edge of the hole (2) so that the
end of the screwdriver presses the spring clip down (1) until one side of the
steering wheel module springs out and releases from the mounting
● Turn the steering wheel a half turn in the opposite direction. Carry out the same
operation on the other side
● Turn the steering wheel to a neutral position.
Installation instructions, accessories
-
Sports steering wheel, wood/leather
Volvo Car Corporation G
öteborg, Sweden
Installation instructions, accessories
-
Sports steering wheel, wood/leather
Volvo Car Corporation G
öteborg, Sweden
©
VolvoCar Corporation, 2005 Printed in Sweden
©
VolvoCar Corporation, 2005 Printed in Sweden
Page 7 of 13
Comments to this Manuals